I've owned my 03 4runner limited for about 7 years now. (l)Ĝlear DTC See: Antilock Brakes / Traction Control Systems\Testing and Inspection\Reading and Clearing Diagnostic Trouble Codes. (k) Turn the ignition switch to the ON position. (i) Repeat the above procedures to bleed the other brake line. (h) When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug. (g) Repeat step (f) until all the air in the brake fluid is bled out. To protect the solenoids, the Techstream turns OFF automatically 2 seconds after every solenoid has been turned ON.
![changing brake light toyota rav4 2004 changing brake light toyota rav4 2004](https://ravenors.files.wordpress.com/2015/03/create-your-own-transparent-materials-in-vray-2.4-featured-image2.png)
![changing brake light toyota rav4 2004 changing brake light toyota rav4 2004](https://ford-sun.ru/wp-content/uploads/zagoraetsya-abs_26.jpg)
(f) Select "TRAC Solenoid (SRMF & SRMR)" to drive the solenoids and bleed air from the rear brake caliper. (d)Ĝonnect the vinyl tube to the rear brake caliper. (c) Select "Active Test" mode on the Techstream. (b) Turn the ignition switch to the ON position. (5) Repeat the above procedures to bleed the other brake line.īLEED MASTER CYLINDER SOLENOID HINT: Perform this step only if the master cylinder solenoid is removed and/or installed. (4) When the air is completely bled out of the brake fluid through the bleeder plug, tighten the bleeder plug. HINT: Brake fluid is sent through the pump, so keep the brake pedal depressed until the air is completely bled out. (3) Loosen the bleeder plug and release air. (1) Turn the ignition switch to the ON position and depress the brake pedal. (6) Repeat the above procedures to bleed the other brake line. (5) Repeat (3) and (4) until all the air in the fluid has been bled out. (4)Ět the point when the fluid stops coming out, tighten the bleeder plug, then release the brake pedal. (3)ĝepress the brake pedal several times, then loosen the bleeder plug with the pedal held down. (2)Ĝonnect the vinyl tube to the brake caliper. (1) Turn the ignition switch to the ON position and wait until the pump motor has stopped. If the pump does not operate as specified, repeat steps (a) to (c) and recheck the operating time. (d) Make sure the pump operates for 8 to 14 seconds.
![changing brake light toyota rav4 2004 changing brake light toyota rav4 2004](https://miro.medium.com/max/730/1*eKTvLBYIUX5HfJYJ-2mJ2Q.png)
(c) Turn the ignition switch to the ON position and start the brake booster pump. (b)ğully depress the brake pedal 10 times. (a) Turn the ignition switch OFF, depress the brake pedal 20 times or more to release the pressure from the accumulator. lines on the reservoir.īLEED BRAKE BOOSTER W/ACCUMULATOR PUMP ASSEMBLY HINT: Perform this step only if the brake booster with accumulator pump assembly is removed and/or installed. When bleeding, keep the amount of the fluid between the Min. If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system. If the brake pedal is depressed with the reservoir cap removed, then brake fluid will spatter. Wash off brake fluid immediately if it comes into contact with a painted surface. The FSM says you only need the computer for bleeding when you have touched the master.